HNC

CNC system faults and troubleshooting more>>

• The Lifting Shaft Dropping when the Emergency Stop Button Being On... [2011-11-15] Detail
• No Hand-held Working Mode [2011-11-15] Detail
• Providing Hand-held working mode but the hand-held unit ineffective... [2011-11-15] Detail
• Internal System Alarming Information... [2011-10-20] Detail

Servo motor faults and troubleshooting more>>

• The Servo Motor Does Not Run [2011-11-15] Detail
• Servo Motor Running only for a Short Period... [2011-11-15] Detail
• Servo Motor Running too Slowly [2011-11-15] Detail
• Low Motor Shaft Output Torque.doc [2011-10-20] Detail

Frequency conversion or servo spindle faults and troubleshooting more>>

• Spindle Overspeed or Uncontrollable [2011-11-15] Detail
• The Spindle Does not Rotate [2011-11-15] Detail
• The Spindle Cannot Stop at the Specified Direction... [2011-11-15] Detail
• Inaccurate Spindle Orientation [2011-10-20] Detail

Running faults and troubleshooting more>>

• The feed Axis Runs Properly at Low Speed But Vibrates or an Alarm Is R... [2011-10-20] Detail
• In Turning Machining, Tool Change Is Performed Before the Axis Moves s... [2011-10-20] Detail
• After the Machine Starts The Tracking Error Is too Large or the Positi... [2011-10-20] Detail